A BIDIRECTIONAL DC–DC PUSH-PULL / FLYBACK CONVERTER

Multiphase Bidirectional Flyback Converter Topology for Induction Motor Drive

For hybrid electric vehicles, the batteries and the drive dc link may be at different voltages. The batteries are at low voltage to obtain higher volumetric efficiencies, and the dc link is at higher voltage to have higher efficiency on the motor side. Therefore, a power interface between the batteries and the drive’s dc link is essential. This power interface should handle power flow from batt...

A novel resonant transition push–pull DC-DC converter

In hard-switched converters, the switching frequency is limited by switching losses and EMI problems. However, high-switching frequency is necessary to reduce the converter size. Hence, soft switching is imperative at high switching frequency to obtain good efficiency. Push–pull converter is a preferred topology at medium power level. This paper proposes a novel resonant transition topology for...

A Three-Phase Current-Fed Push–Pull DC–DC Converter

In this paper, a new three-phase current-fed push– pull dc–dc converter is proposed. This converter uses a highfrequency three-phase transformer that provides galvanic isolation between the power source and the load. The three active switches are connected to the same reference, which simplifies the gate drive circuitry. Reduction of the input current ripple and the output voltage ripple is ach...

A New Zero-Voltage-Switching Push-Pull Converter

A soft switching three-transistor push-pull(TTPP)converter is proposed in this paper. The 3rd transistor is inserted in the primary side of a traditional push-pull converter. Two primitive transistors can achieve zero-voltage-switching (ZVS) easily under a wide load range, the 3rd transistor can also realize zero-voltage-switching assisted by leakage inductance. The rated voltage of the 3rd tra...

Step up dcdc converter pdf