A 5G graphene antenna produced by screen printing method
نویسندگان
چکیده
منابع مشابه
Pulsed Polarization-Based NOx Sensors of YSZ Films Produced by the Aerosol Deposition Method and by Screen-Printing
The pulsed polarization technique on solid electrolytes is based on alternating potential pulses interrupted by self-discharge pauses. Since even small concentrations of nitrogen oxides (NOx) in the ppm range significantly change the polarization and discharge behavior, pulsed polarization sensors are well suited to measure low amounts of NOx. In contrast to all previous investigations, planar ...
متن کاملThin Film Solar Cells by Screen Printing Technology
General properties of thin film solar cells and panels are discussed, and compared to crystalline silicon. A state-of-the-art of thin film cells and panels is given. One thin film production technique is elaborated: screen printing and sintering. The technique and its application to CdS/CdTe cells are presented. It is shown that sophistication to the basic technique can overcome inherent shortc...
متن کاملHighly efficient phosphorescent polymer OLEDs fabricated by screen printing
We demonstrate the use of screen printing in the fabrication of highly efficient phosphorescent polymer organic light-emitting devices (OLEDs) based on a green-emitting Ir(ppy)3 and a host polymer PVK. We incorporate PBD in the polymer host as an electron-transporting dopant and a-NPD as a hole-transporting dopant. The best screen-printed single-layer device exhibits very high peak luminous eff...
متن کاملsolution of security constrained unit commitment problem by a new multi-objective optimization method
چکیده-پخش بار بهینه به عنوان یکی از ابزار زیر بنایی برای تحلیل سیستم های قدرت پیچیده ،برای مدت طولانی مورد بررسی قرار گرفته است.پخش بار بهینه توابع هدف یک سیستم قدرت از جمله تابع هزینه سوخت ،آلودگی ،تلفات را بهینه می کند،و هم زمان قیود سیستم قدرت را نیز برآورده می کند.در کلی ترین حالتopf یک مساله بهینه سازی غیر خطی ،غیر محدب،مقیاس بزرگ،و ایستا می باشد که می تواند شامل متغیرهای کنترلی پیوسته و گ...
Formation and stability of lines produced by inkjet printing.
To produce stable lines with parallel sides through inkjet printing, individual drops are deposited on a surface so that they coalesce; this initial liquid line (or bead) must remain stable until it forms a solid. The stable line width is shown to be bounded by two limits, with the lower bound (minimum line width) determined by the maximum drop spacing for stable coalescence and the upper bound...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indonesian Journal of Electrical Engineering and Computer Science
سال: 2019
ISSN: 2502-4760,2502-4752
DOI: 10.11591/ijeecs.v15.i2.pp950-955