A 4Gb/s, 370µA low-power Tx FIR driver for LPDDR4 applications
نویسندگان
چکیده
منابع مشابه
Subthreshold FIR Filter Architecture for Ultra Low Power Applications
Subthreshold design has been proposed as an effective technique for designing signal processing circuits needed in wireless sensor nodes powered by sources with limited energy. In this paper we propose a subthreshold FIR architecture which brings the benefits of reduced leakage energy, reduced minimum energy point, reduced operating voltage and increased operating frequency when compared with r...
متن کاملIGBT Gate Driver Solutions for Low and Medium Power Applications
Issue 6 2010 Power Electronics Europe www.power-mag.com Power electronics systems are commonly used in motor drive, power supply and power conversion applications. They cover a wide output power spectrum: from several hundred watts in small drives up to megawatts in wind power installations or large drive systems. Inside the system the gate driver circuit with its extensive control and monitori...
متن کاملLow Power Vlsi Design of a Fir
Digital signal processing is an area of science and engineering that has developed rapidly over the past 30 years. This rapid development is a result of the significant advances in digital computer technology and integrated–circuit fabrication. DSP processors are a diverse group, most share some common features designed to support fast execution of the repetitive, numerically intensive computat...
متن کاملA Low-Power Asynchronous VLSI FIR Filter
An asynchronous FIR filter, based on a Single Bit-Plane architecture with a data-dependent, dynamic-logic implementation, is presented. Its energy consumption and sample computation delay are shown to correlate approximately linearly with the total number of ones in its coeflcient-set. The proposed architecture has the property that coefficients in a SignMagnitude representation can be handled ...
متن کاملA Low-Voltage, Low-Power, Two-Stage Amplifier for Switched-Capacitor Applications in 90 nm CMOS Process
Abstract- A novel low-voltage two-stage operational amplifier employing resistive biasing is presented. This amplifier implements neutralization and correction common mode stability in second stage while employs capacitive dc level shifter and coupling between two stages. The structure reduces the power consumption and increases output voltage swing. The compensation is performed by simple mill...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2014
ISSN: 1349-2543
DOI: 10.1587/elex.10.20130825