A 2:1 MUX Based on Multiple MEMS Resonators
نویسندگان
چکیده
منابع مشابه
Active sensing in silicon-based MEMS resonators
Microelectromechanical resonators are advantageous over traditional LC tanks and off-chip quartz crystals due to their high quality factors, small size and low power consumption. FET-sensing has been demonstrated in resonant body transistors (RBTs) to reach an order of magnitude higher frequencies than possible with passive resonators due to the greater sensing efficiency of FET sensing over tr...
متن کاملResearch Issues in MEMS Resonators
MEMS resonators have started replacing the quartz crystals and SAW resonators in RF transceivers because of their inherent advantages like high quality factor, small size, robustness and easy integrability with supporting electronics. The paper presents the developments that have taken place in MEMS resonators. Some of the issues in the design and development of electrostatically transduced MEM...
متن کاملA mode-localized MEMS electrical potential sensor based on three electrically coupled resonators
We report a new class of MEMS resonant potential sensor based on the mode localization effect using a 3-degree-of-freedom (DoF) electrically weakly coupled resonator system. As opposed to previously reported electrically coupled 2DoF mode-localized resonant sensors, it can be shown in theory that the 3DoF structure has an improved sensitivity without sacrificing signal transduction, in addition...
متن کاملAn On-Chip Test Circuit for Characterization of MEMS Resonators
There has been much interest in developing microelectromechanical systems (MEMS) resonators that achieve comparable performance to traditional resonators yet have smaller footprint and are compatible with CMOS. Recently, MEMS resonators have been proposed that overcome physical limitations in traditional resonators to reach frequencies in the GHz range and that have the potential for compatibil...
متن کاملMEMS Resonators: Getting the Packaging Right
Microelectromechanical Systems (MEMS) resonators have been investigated for over forty years but have never delivered the high performance and low cost required of commercial oscillators. Packaging technology has been one of the primary limitations. MEMS resonators must be enclosed in very clean environments because even small amounts of surface contamination can significantly change resonator ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2016
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2016.11.480