A 125–170 GHz wideband high-power amplifier using 0.5-µm InP DHBT
نویسندگان
چکیده
منابع مشابه
A 125-170 GHz wideband high-power amplifier using 0.5-µm InP DHBT
In this paper, a D-band power amplifier (PA) based on 0.5-μm InP DHBT is presented. Wilkinson combiners with broadband stepped-impedance matching are used, and the eight-way PA is designed for wideband power performance. As input power is fixed at 3 dBm, the PA exhibits a saturated output power of 16.8 dBm and 7.9% PAE at 150 GHz with >45-GHz 3-dB power bandwidth from 125 GHz to 170 GHz. Meanwh...
متن کاملMillimeterwave INP DHBT power amplifier based on poweroptimized cascode configuration
This letter describes the use of a power-optimized cascode configuration for obtaining maximum output power at millimeter-wave (mm-wave) frequencies for a two-way combined power amplifier (PA). The PA has been fabricated in a high-speed InP double heterojunction bipolar transistor technology and has a total active emitter area of 68.4 lm2. The experimental results demonstrate a small signal gai...
متن کاملA 28-36 GHz Optimized CMOS Distributed Doherty Power Amplifier with A New Wideband Power Divider Structure
Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...
متن کاملA novel wideband 140 GHz gyrotron amplifier
The theory, design and experimental results of a wideband 140 GHz, 1 kW pulsed gyro-traveling wave amplifier are presented. The gyro-TWA operates in the HE(0,6) mode of a novel cylindrical confocal waveguide using a gyrating electron beam. The electromagnetic theory, interaction theory, design processes and experimental procedures have been described in detail. The experiment has produced over ...
متن کامل140-220 GHz Imaging Front-end Based on 250 nm InP/InGaAs/InP DHBT Process
This paper presents a pre-amplified detector receiver based on a 250 nm InP/InGaAs/InP double heterojunction bipolar transistor (DHBT) process available from the Teledyne scientific. The front end consists of a double slot antenna followed by a five stage low noise amplifier and a detector, all integrated onto the same circuit. Results of measured responsivity and noise are presented. The recei...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2017
ISSN: 1349-2543
DOI: 10.1587/elex.14.20170684