A 0.4–6-GHz 17-dBm B1dB 36-dBm IIP3 Channel-Selecting Low-Noise Amplifier for SAW-Less 3G/4G FDD Diversity Receivers
نویسندگان
چکیده
منابع مشابه
A Concurrent Dual-Band Low Noise Amplifier for GNSS Receivers
In this paper, a new design of concurrent dual-band Low Noise Amplifier (LNA) for multi-band single-channel Global Navigation Satellite System (GNSS) receivers is proposed. This new structure is able to operate concurrently at frequency of 1.2 and 1.57 GHz. Parallel and series resonance parts are employed in the input matching in order to achieve concurrent performance. With respect to used pse...
متن کاملA Low-Power Active Self-Interference Cancellation Technique for SAW-Less FDD and Full-Duplex Receivers
An active self-interference (SI) cancellation technique for SAW-less receiver linearity improvement is proposed. The active canceler combines programmable gain and phase in a single stage and is co-designed with a highly-linear LNA, achieving low noise and low power. A cross-modulation mechanism of the SI canceler is identified and strongly suppressed thanks to the introduction of an internal r...
متن کاملA 10 dBm 2.4 GHz CMOS PA
This report describes the assessment and design of a 10 dBm 2.4 GHz CMOS PA including driver stage. The PA is designed in a 0.18 μm CMOS technology. A three stage PA has been designed due to the high voltage gain needed. Class F has been chosen for the output stage. An output filter short-circuiting the second harmonic frequency and reflecting the third harmonic frequency is used to obtain the ...
متن کاملTunable selective receiver front end with impedance transformation filtering
A highly selective impedance transformation filtering technique suitable for tunable selective RF receivers is proposed in this paper. To achieve blocker rejection comparable to SAW filters, we use a two stage architecture based on a low noise trans-conductance amplifier (LNTA). The filter rejection is captured by a linear periodically varying (LPV) model that includes band limitation by the LN...
متن کاملA 335 μ W - 72 dBm Receiver for FSK Back - Channel Embedded in 5 . 8 GHz
An ULP back-channel receiver is presented that demodulates binary a FSK back-channel signal embedded in 5.8GHz IEEE 802.11a Wi-Fi OFDM packets. The architecture of the back-channel receiver employs a two-step downconversion where the first mixing stage downconverts using the 3rd harmonic of the LO for power efficiency. The LP-65nm CMOS receiver consumes 335μW with a sensitivity of -72dBm at a B...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Microwave Theory and Techniques
سال: 2016
ISSN: 0018-9480,1557-9670
DOI: 10.1109/tmtt.2016.2529598