A 0.2–6 GHz linearized Darlington-cascode broadband power amplifier
نویسندگان
چکیده
منابع مشابه
A 2.4-GHz 0.18- m CMOS Self-Biased Cascode Power Amplifier
A two-stage self-biased cascode power amplifier in 0.18m CMOS process for Class-1 Bluetooth application is presented. The power amplifier provides 23-dBm output power with a power-added efficiency (PAE) of 42% at 2.4 GHz. It has a small signal gain of 38 dB and a large signal gain of 31 dB at saturation. This is the highest gain reported for a two-stage design in CMOS at the 0.8–2.4-GHz frequen...
متن کاملA CMOS Class-E Cascode Power Amplifier for GSM Application
The design of A 2.4-GHz CMOS Class E cascode power amplifier (PA) for GSM applications in TSMC 0.18-μm CMOS technology present in this paper. Proposed Class E cascode PA topology is a single-stage topology in order to minimize the device stress problem. A parallel capacitor is connected across the transistors for efficiency enrichment also for dominating the effect of parasitic capacitances at ...
متن کاملA Low Noise Cascode Amplifier
A low noise amplifier has been designed using a 2SK117 N channel J-FET as the input device in a cascode [1] configuration. Noise measurements on this amplifier yield a low frequency noise current of 0.25 fA/Yfu and a voltage noise of less than 1.2 n V NHz in the 500 Hz to 50 kHz region. Bloyet et al. [2] suggest a figure of merit of the product of the noise voltage and current as being appropri...
متن کاملA 0.6-22-GHz Broadband CMOS Distributed Amplifier
[51 Bondwire inductors 0.3 3 5 * 1.2 0 . 7 2 ~ 0.32 5.1 7 4.7 c -6 4 9 3 54 Abstrncf A CMOS distributed amplifier (DA) covering 0.6 to 22 GHz is presented in this paper. Cascode gain cells and m-derived matching sections are used to enhance the gain and bandwidth performance. The DA chip achieves measured gain of 7.3 f 0.8 dB with chip area of 0.9 x 1.5 mm’ including testing pads. The amplifier...
متن کاملA Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers
A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2018
ISSN: 1349-2543
DOI: 10.1587/elex.15.20180298