A 0.24-nJ/bit Super-Regenerative Pulsed UWB Receiver in 0.18-$\mu$m CMOS
نویسندگان
چکیده
منابع مشابه
A 350μW CMOS MSK Transmitter and 400μW OOK Super-Regenerative Receiver for Medical Implant Communications
A 350μW MSK direct modulation transmitter and a 400μW OOK super-regenerative receiver (SRR) are implemented in 90nm CMOS technology. The transceiver tunes 24MHz in frequency steps smaller than 2kHz and is designed to meet the specifications of the Medical Implant Communications Service (MICS) standard in the 402–405MHz band. The transmitter meets MICS mask specifications with data rates up to 1...
متن کاملSuper-Regenerative Receiver (SRR) for short- range HF band applications
This master thesis describes a radio receiver with simple architecture which operates at 20 MHz. This is based on low-cost amplifier design. Super-regenerative receiver (SRR) is re-examined for its simplicity, low-power, and short-range wireless applications. Power consumption is kept to a minimal level without any change in the performance of receiver by providing minimum biasing to discrete d...
متن کاملOOK Super-Regenerative Receiver for Medical Implant Communications
Recent advances in the medical field are spurring the need for ultra-low power transceivers for wireless communication with medical implants. To deal with the growing demand for medical telemetry, the FCC commissioned the Medical Implant Communications Services (MICS) standard in 1999 in the 402–405 MHz band. This paper presents a 350 W FSK/MSK direct modulation transmitter and a 400 W OOK supe...
متن کاملA 22–29-GHz UWB Pulse-Radar Receiver Front-End in 0.18- m CMOS
The design of a CMOS 22–29-GHz pulse-radar receiver (RX) front-end for ultra-wideband automotive radar sensors is presented. The chip includes a low-noise amplifier, in-phase/quadrature mixers, a quadrature voltage-controlled oscillator (QVCO), pulse formers, and baseband variable-gain amplifiers. Fabricated in a 0.18m CMOS process, the RX front-end chip occupies a die area of 3 mm . On-wafer m...
متن کاملA low power 3–5 GHz CMOS UWB receiver front-end∗
A novel low power RF receiver front-end for 3–5 GHz UWB is presented. Designed in the 0.13 μm CMOS process, the direct conversion receiver features a wideband balun-coupled noise cancelling transconductance input stage, followed by quadrature passive mixers and transimpedance loading amplifiers. Measurement results show that the receiver achieves an input return loss below −8.5 dB across the 3....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Journal of Solid-State Circuits
سال: 2011
ISSN: 0018-9200,1558-173X
DOI: 10.1109/jssc.2011.2166434