808 nm broad-area laser diodes designed for high efficiency at high-temperature operation
نویسندگان
چکیده
منابع مشابه
RPC operation at high temperature
The resistive electrodes of RPCs utilised in several current experiments (ATLAS, CMS, ALICE, BABAR and ARGO) are made of phenolic/melaminic polymers, with room temperature resistivities ranging from 10 O cm; for high rate operation in avalanche mode, to 5 10 O cm; for streamer mode operation at low rate. The resistivity has however a strong temperature dependence, decreasing exponentially with ...
متن کامل980 nm high brightness external cavity broad area diode laser bar.
We demonstrate off-axis spectral beam combining applied to a 980 nm high power broad area diode laser bar. The experiments yielded 9 W of optical power at 30 A of operating current and the measured M2 values of the combined beam from 12 emitters were 1.9 and 6.4 for the fast and the slow axis, respectively. The slow axis beam quality was 5-6 times better than the value obtained from a single em...
متن کاملTreatment of lentigines by a novel high power diode laser at 755 nm: a case report
The use of high-power diode laser with a wavelength of 755 nm is an effective and safe method for the correction and partial and/or total elimination of pigmented lesions, specifically solar lentigines. This wavelength has yet not been used in diode lasers to treat solar lentigines. Side effects are the usual ones, including darkening and scab formation. Our patient was a 40-year-old woman of C...
متن کاملHigh Reliability and High Performance of 9xx nm Single Emitter Laser Diodes
Improved performance and reliability of 9xx nm single emitter laser diodes are presented. To date, over 15,000 hours of accelerated multi-cell lifetest reliability data has been collected, with drive currents from 14A to 18A and junction temperatures ranging from 60C to 110C. Out of 208 devices, 14 failures have been observed so far. Using established accelerated lifetest analysis techniques,...
متن کاملHigh-power and High Efficiency Yb:YAG Ceramic Laser at Room Temperature
Ceramic laser media fabricated by vacuum sintering (Ikesue et al., 1995), (Ikesue et al., 1996), and nanocrystalline (Lu et al., 2000) technology are very attractive materials because they have several remarkable advantages compared with single crystal laser materials. Ceramic samples with a large size can be easily fabricated, whereas this is extremely difficult for single crystals; multiplaye...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Semiconductor Science and Technology
سال: 2021
ISSN: ['0268-1242', '1361-6641']
DOI: https://doi.org/10.1088/1361-6641/ac2160