3D printed nanofiltration composite membranes with reduced concentration polarisation

نویسندگان

چکیده

3D printed nanofiltration (NF) composite membranes with surface patterns minimising the impact of concentration polarisation (CP) are presented here for first time. The consist a NF polydopamine?coated polyvinylidene fluoride (PVDF/PDA) selective layer on asymmetric wavy (patterned) support. result is membrane pure water permeance 14 ± 2 LMH bar ? 1 and molecular weight cut-off ?550 Da, measured using crossflow setup at transmembrane pressure Reynold number ( Re ) 700, range dyes (mass balance >97% all tests). CP behaviour was assessed by filtration Congo red (CR) dye solution (0.01 g L , showing that pattern significantly reduced compared to flat membranes, nearly tripling mass transfer coefficient 57% decline factor. Computational fluid dynamics showed these significant performance improvements were due improved hydrodynamics, maximum shear stress induced structure (1.35 Pa) an order magnitude higher than (0.18 = 700. These results demonstrate printing viable technology route reducing in applications. • Fabrication via patterns. Wavy had PWP MWCO Da. Concentration solution. led lower triple coefficient. Shear over one.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Cellulose Acetate Nanofiltration Membranes for Cadmium Remediation

In this work, cellulose acetate (CA) nanofiltration (NF) membranes were prepared via non-solvent phase inversion technique (NIPS). Polymer concentration was varied from 22 to 25 wt% in order to study its effect on the membrane properties. The fabricated membranes were characterized in terms of morphological analysis using scanning electron microscopy (SEM), contact angle, water content, water p...

متن کامل

Anionic/Non-ionic Surfactants in Aqueous Phase of Thin Film Composite Poly(Paraphenylene Terephthalamide) Nanofiltration Membranes

In this work, the Interfacial interfacial polymerization (IP) technique was employed using terephthaloyl chloride (TPC) and p-phenylenediamine (PPD), as reactant monomers, to prepare poly(paraphenylene terephthalamide) thin film composite (TFC) nanofiltration on polyethersulphone (PES) support layer. The effects of six different anionic and non-ionic surfactants, in the aqueous phase on the mor...

متن کامل

Preparation of Novel Thin-Film Composite Nanofiltration Membranes for Separation of Amoxicillin

Several novel composite membranes were prepared to separate and recycle amoxicillin from pharmaceutical wastewater via nanofiltration process. The synthesis of these membranes included three stages: 1- preparation of polysulfone ultrafiltration membranes as a support via phase separation process, 2- modification of its surface by interfacial polymerization as a selective layer (polyamide), and ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Membrane Science

سال: 2022

ISSN: ['1873-3123', '0376-7388']

DOI: https://doi.org/10.1016/j.memsci.2021.120137