3077 Friction Loss in Rubber Flexible Air Duct(Environmental Engineering)
نویسندگان
چکیده
منابع مشابه
Rubber friction and tire dynamics.
We propose a simple rubber friction law, which can be used, for example, in models of tire (and vehicle) dynamics. The friction law is tested by comparing numerical results to the full rubber friction theory (Persson 2006 J. Phys.: Condens. Matter 18 7789). Good agreement is found between the two theories. We describe a two-dimensional (2D) tire model which combines the rubber friction model wi...
متن کاملRubber Friction in Aqueous Solutions Containing Ions
Lubricants ordinarily operate by keeping two sliding surfaces separated. The efficiency of a lubricant may be expressed by equations of hydrodynamics where the mechanical properties of the films of lubricants are adequately defined by the properties of bulk lubricant. In the case of water lubrication of black rubber at slow speeds and low pressures the lubricating ability of water is shown to b...
متن کاملSliding friction at a rubber/brush interface.
We study the friction of a poly(dimethylsiloxane) (PDMS) rubber network sliding, at low velocity, on a substrate on which PDMS chains are end-tethered. We thus clearly evidence the contribution to friction of the pullout mechanism of chain ends that penetrate into the network. This interfacial dissipative process is systematically investigated by probing the velocity dependence of the friction ...
متن کاملOn the theory of rubber friction
Rubber exhibits unusual sliding friction. When rubber is slid on a hard, rough substrate, the surface asperities of the substrate exert oscillating forces on the rubber surface leading to energy ‘‘dissipation’’ via the internal friction of the rubber. I estimate this contribution to the friction force and compare the results with the experimental data of Grosch. Because of its low elastic modul...
متن کاملRubber friction: comparison of theory with experiment.
We have measured the friction force acting on a rubber block slid on a concrete surface. We used both unfilled and filled (with carbon black) styrene butadiene (SB) rubber and have varied the temperature from -10 °C to 100 °C and the sliding velocity from 1 μm/s to 1000 μm/s. We find that the experimental data at different temperatures can be shifted into a smooth master-curve, using the temper...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Architectural Institute of Japan Summaries of Technical Papers
سال: 1967
ISSN: 2433-0035
DOI: 10.3130/aijsaxxe.42.0_561