3-dimensional numerical modelling of rolling of superconducting Ag/BSCCO tape
نویسندگان
چکیده
منابع مشابه
MODELLING OF ROLLING OF SUPERCONDUCTING Ag/BSCCO TAPE
Numerical simulation of the deformation process during flat rolling of multifilament HTS tapes has been investigated using a commercial FEM program, ELFEN. The numerical models were built up in 2D and 3D using a DruckerPragerKap model for the powder. Three different roll diameters (024 mm, 0 8 5 mm and 0126 mm) have been investigated. It is found that it is possible to perform numerical simulat...
متن کاملTape-Spring Rolling Hinges
This paper presents a new design of a low cost, unlubricated, self-deploying, self-locking hinge whose properties can be easily modified to meet different requirements. A particular implementation is considered, providing a hinge that is 135 mm long, 30 mm high and 45 mm wide, with a deployment moment varying between 0.1 and 0.3 Nm and a locking moment of 13 Nm. Stiffness tests have been carrie...
متن کاملNumerical Simulation of Flash Boiling Effect in a 3-Dimensional Chamber Using CFD Techniques
Flash Boiling atomization is one of the most effective means of generating a fine and narrow-dispersed spray. Unless its complexity its potential has not been fully realized. In This Paper, a three dimensional chamber has been modeled with a straight fuel injector. Effect of Flash Boiling has been investigated by computational fluid dynamics (CFD) techniques. A finite volume approach with the ...
متن کاملA Full-Cycle 3 Dimensional Numerical Simulation of a Direct Injection Diesel Engine
In the present work, multidimensional modeling of open-cycle process of OM355 engine was developed. Calculations for computational mesh were carried out. The results of the model were validated by experimentally measured in-cylinder pressure and the good agreement between calculations and measurements approved the trustworthy of numerical code. Results included pressure, temperature, emissi...
متن کاملNumerical Modelling of the Segmental Lining of Underground Structures
There are several methods for analysing the behaviour of underground structures under different loading conditions. Most of these methods have many simplifications; therefore, in some cases, the results are too conservative and a very high safety factor, usually of more than 2 is needed. On the other hand, for stability analysis and the designing of support systems, these methods consider segme...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Appiled Superconductivity
سال: 2001
ISSN: 1051-8223
DOI: 10.1109/77.919881