3 dB Coupler for UHF 30 kW Transmitter
نویسندگان
چکیده
منابع مشابه
Miniaturization of Broadband 3-db Branch- Line Coupler
In this letter, a new miniaturized broadband 3-dB branchline coupler at the center frequency of 880 MHz is proposed. The proposed coupler is designed by means of integrated miniaturization method, which consists of shunt capacitors, fractal geometry and equivalent miniaturized stubs, to achieve 82% size reduction compared with the referenced coupler. The return loss and isolation are both under...
متن کاملNovel Broadband 3-dB Directional Coupler Design Method
─ A novel broadband 3-dB directional coupler design method utilizing HFSS and realization are given in this paper. It is realized in stripline, showing great agreement with the simulation and design format. The unique property of this design method is that it unnecessitates both a feedback from the realization for broadbanding and an additional smoothing of transition between coupled sections o...
متن کاملBroadband and Small-size 3-dB Ring Coupler
A topology for a 3-dB broadband and small-size ring coupler is proposed. It consists of fully-distributed Composite Right-/Left-Handed phase shifters and a Lange coupler. For the fabricated coupler, the frequency bandwidth is one octave, centered on 1.5GHz, while the footprint area is reduced to 25%, compared to the conventional ring coupler topology. The experimental results are in good agreem...
متن کاملUHF RF Transmitter and Receiver
Here we propose a current mode oscillator circuit using Q-Dot technology and subsequently we modify this circuit for transmitter and receiver design. We like to note that transmitter is a amplitude modulation (AM) to frequency modulation (FM) conversion technique. The receiver is of Super heterodyne structure, where the RF front end is implemented by Q-Dot devices and the IF stages are implemen...
متن کاملDesign of a Novel 3 Db Microstrip Backward Wave Coupler Using Defected Ground Structure
In this paper an edge coupled microstrip coupler with defected ground structure is presented. A normally 7 dB coupler designed on Alumina substrate is converted into a 3 dB coupler by cutting single rectangular slot in the ground plane encompassing the two transmission lines. Other properties of backward wave coupler remain the same, except for a tighter coupling. With this method of design opt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Institute of Television Engineers of Japan
سال: 1971
ISSN: 1884-9644
DOI: 10.3169/itej1954.25.126