25 W solid state power combining amplifier in Ka-band
نویسندگان
چکیده
منابع مشابه
Ka-Band Wideband-Gap Solid-State Power Amplifier: General Architecture Considerations
Motivated by recent advances in wideband-gap (WBG) gallium nitride (GaN) semiconductor technology, there is considerable interest in developing efficient solidstate power amplifiers (SSPAs) as an alternative to the traveling-wave tube amplifier (TWTA) for space applications. This article documents the general architecture considerations pertinent to developing SSPA architectures that can enable...
متن کاملA 120-W -Band Spatially Combined Solid-State Amplifier
In this paper, we present new results in the development of a broad-band spatial power-combining system implemented in a standard X-band waveguide environment. Using 24 off-the-shelf GaAs monolithic-microwave integrated-circuit (MMIC) power amplifiers integrated with tapered-slot antenna arrays, the new combining circuit produced up to 126-W maximum power output with a gain variation of 1.9 dB ...
متن کاملBroad-Band High-Power Amplifier Using Spatial Power-Combining Technique
High power, broad bandwidth, high linearity, and low noise are among the most important features in amplifier design. The broad-band spatial power-combining technique addresses all these issues by combining the output power of a large quantity of microwave monolithic integrated circuit (MMIC) amplifiers in a broad-band coaxial waveguide environment, while maintaining good linearity and improvin...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملdesign, optimization and analysis of high power amplifier in the ka band
the graphical technique for nonlinear circuits was described that enable us to optimize circuits to obtain maximum output power, maximum efficiency or minimum intermodulation. according to this method a high power amplifier in the ka band was designed. using a nonlinear model of the transistor, optimum slope for load-line was determined so that maximum power at the output was obtainable, then ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF INFRARED AND MILLIMETER WAVES
سال: 2012
ISSN: 1001-9014
DOI: 10.3724/sp.j.1010.2011.00347