22–27 GHz 11 dB inductive feedback cascode amplifier with 12 picoseconds group delay variation
نویسندگان
چکیده
منابع مشابه
3 - 10 GHz Ultra-Wideband Low-Noise Amplifier Using Inductive-Series Peaking Technique with Cascode Common-Source Circuit
The objective of this paper is to investigate a ultra-wideband (UWB) low noise amplifier (LNA) by utilizing a two-stage cascade circuit schematic associated with inductive-series peaking technique, which can improve the bandwidth in the 3 10 GHz microwave monolithic integrated circuit (MMIC). The proposed UWB LNA amplifier was implemented with both co-planer waveguide (CPW) layout and 0.15 μm G...
متن کاملA 2 GHz CMOS dB-Linear Amplifier with 51 dB D
A 2 GHz programmable-gain amplifier (PGA) using 0.12-μm CMOS technology is presented in this paper, which has a 51 dB gain control range with 3 dB gain control steps. The maximum output power of this PGA achieves 9 dBm while the 1-dB compression point is located at 8 dBm. A high linearity denoted by the oIP3 of 22 dBm at the maximum gain has been achieved. A new configuration to digitally imple...
متن کاملDesign Of 11 GHz Ku-Band Amplifier
Abstarct Amplification is one of the most basic and prevalent RF/Microwave circuit functions. This paper describes the design of an 11 GHz PHEMT ATF-36077 microwave amplifier. The amplifier is manually designed using conventional technique, Smith chart was used to do a matching of the input and output of the amplifier. A completed design of the amplifier was optimised using Hewlett-Packard Adva...
متن کاملA Low Noise Cascode Amplifier
A low noise amplifier has been designed using a 2SK117 N channel J-FET as the input device in a cascode [1] configuration. Noise measurements on this amplifier yield a low frequency noise current of 0.25 fA/Yfu and a voltage noise of less than 1.2 n V NHz in the 500 Hz to 50 kHz region. Bloyet et al. [2] suggest a figure of merit of the product of the noise voltage and current as being appropri...
متن کاملA 2.4-GHz 0.18- m CMOS Self-Biased Cascode Power Amplifier
A two-stage self-biased cascode power amplifier in 0.18m CMOS process for Class-1 Bluetooth application is presented. The power amplifier provides 23-dBm output power with a power-added efficiency (PAE) of 42% at 2.4 GHz. It has a small signal gain of 38 dB and a large signal gain of 31 dB at saturation. This is the highest gain reported for a two-stage design in CMOS at the 0.8–2.4-GHz frequen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2016
ISSN: 1349-2543
DOI: 10.1587/elex.13.20160862