2082) Approximate Bending Stresses in Unclosed Conical Shells(Structure)
نویسندگان
چکیده
منابع مشابه
Detection of Bending Stresses in Buried Pipelines
When gas or oil pipelines must be laid through sand or permafrost or other unstable soils, the pipe walls can he subjected to large bending loads if the soil shifts. In order to detect this condition and correct it, it would be useful to monitor the state of stress along the pipeline'at regular time intervals using a vehicle that is moved through the line by the fluid or gas in it. The experime...
متن کاملAnalysis of Bending Stresses in Cantilever Type Suction Valve Reeds
Design techniques are described which allow prediction of bending stresses in reed valves from theoretical and experimental data. Their application is to aid the development of more durable valves. A relatively simple analysis is described which permits valve stresses and impact velocities to be estimated from the initial pressure drop across a valve reed. (Conversely, experimental measurement ...
متن کاملMicro-Raman Measurement of Bending Stresses in Micromachined Silicon Flexures
Micron-scale characterization of mechanical stresses is essential for the successful design and operation of many micromachined devices. Here we report the use of Raman spectroscopy to measure the bending stresses in deep reactive-ion etched silicon flexures with a stress resolution of 10 MPa and spatial resolution of 1 m. The accuracy of the technique, as assessed by comparison to analytical a...
متن کاملTechniques to carry weight loads and resist against bending in conical shells, cases in Kashan
Little has been written about the structural behavior of conical shells, while conical shells’ construction techniques due to the high rise and small span has always required special attention throughout the history of Islamic architecture. This paper aims to examine how conical shells bear weight loads and resist against bending through a qualitative analysis. After proving that ‘r...
متن کاملAnalysis of Thermal-Bending Stresses in a Simply Supported Annular Sector Plate
The present article deals with the analysis of thermal-bending stresses in a heated thin annular sector plate with simply supported boundary condition under transient temperature distribution using Berger’s approximate methods. The sectional heat supply is on the top face of the plate whereas the bottom face is kept at zero temperature. In this study, the solution of heat conduction is obtained...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Architectural Institute of Japan
سال: 1964
ISSN: 0387-1185,2433-0027
DOI: 10.3130/aijsaxx.103.0_138