1.2–2.8-GHz 32.4-dBm Digital Power Amplifier With Balance-Compensated Matching Network
نویسندگان
چکیده
In this letter, a wideband watt-level digital power amplifier (DPA) with balance-compensated matching network is proposed for polar transmitters. The balance response of the differential to single-ended transformer enhanced by series-loaded compensation capacitor, which leads improvement DPA efficiency. To verify mechanisms, prototype fabricated in conventional 40-nm CMOS technology. operates over 1.2-2.8 GHz and exhibits peak output 32.4 dBm at 2 drain efficiency 53.8% 1.8 GHz. It supports 50-MHz 64-quadratic-amplitude modulation (QAM) average (P avg ) 25.37 dBm, error vector magnitude (EVM) -26.97 dB, adjacent channel ratio (ACPR) -29.61 dBc, 10-MHz 1024-QAM P 22.14 EVM -35.75 ACPR -35.37 respectively.
منابع مشابه
A D-BAND POWER AMPLIFIER WITH 30-GHz BAND- WIDTH AND 4.5-DBM Psat FOR HIGH-SPEED COMMU- NICATION SYSTEM
This paper presents a D-band power amplifier for highspeed communication system. The capacitive effect of interconnection via on transistor performance at high frequency is analyzed and a new via structure is employed to reduce the capacitive effect. The on-chip matching technique for high frequency amplifier is analyzed and the thin-film microstrip line matching network is used, which is combi...
متن کامل24 GHz Stacked Power Amplifier With Optimum Inter-stage Matching Using 0.13 μm CMOS Process
A single-stage 24 GHz triple stacked power amplifier using 0.13 μm CMOS process is demonstrated. To Compare with parallel current combining method, series voltage combining method using a stacked amplifier architecture can realize a large output voltage swing from the top transistor without exceeding the transistor breakdown voltage limitations. However, at high frequencies, parasitic capacitan...
متن کاملA 28-36 GHz Optimized CMOS Distributed Doherty Power Amplifier with A New Wideband Power Divider Structure
Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...
متن کاملGHz WLAN InGaP / GaAs Power Amplifier with Temperature Compensation Technique
© 2009 Sang-Woong Yoon et al. 601 ABSTRACT⎯This letter presents a high performance 2.4 GHz two-stage power amplifier (PA) operating in the temperature range from -30C to +85C for IEEE 802.11g, wireless local area network application. It is implemented in InGaP/GaAs hetero-junction bipolar transistor technology and has a bias circuit employing a temperature compensation technique for error vecto...
متن کاملLow-Power Power Amplifier for 77-GHz Automotive Radars
In this paper we present low-power 77-GHz power amplifier (PA) for the long range automotive radar. The proposed amplifier is designed using TSMC 0.13-μm RF CMOS (fT/fmax=120/140 GHz) technology, and it is powered by a 1.5V supply. To reduce power dissipation, we consider bias voltage, transistor size optimization, matchings and layout optimization. To improve power gain of the amplifier, it ha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Microwave and Wireless Components Letters
سال: 2021
ISSN: ['1531-1309', '1558-1764']
DOI: https://doi.org/10.1109/lmwc.2020.3035218