0n a Curvilinear Strain Gage for Stress Analysis
نویسندگان
چکیده
منابع مشابه
Pattern of Residual Stress in Rail by FEM Analysis and Strain Gage Sectioning Technique
Final step of rail manufacturing is cold rolling straightening process and it hassignificant effects on mechanical properties, straightness, flatness and development of residualstresses. Measurement of residual stresses after straightening process is obligated by railmanufacturing standards. In the present investigation, an attempt has been made to evaluateresidual stresses after straightening ...
متن کاملpattern of residual stress in rail by fem analysis and strain gage sectioning technique
final step of rail manufacturing is cold rolling straightening process and it hassignificant effects on mechanical properties, straightness, flatness and development of residualstresses. measurement of residual stresses after straightening process is obligated by railmanufacturing standards. in the present investigation, an attempt has been made to evaluateresidual stresses after straightening ...
متن کاملStrain Gage Measurements on Plastics and Composites
The bonded resistance strain gage, which is central to the topics treated here, was invented in the late 1930's and is now at about the mid-century mark in its career. During the first fifty years of its existence, the strain gage has been applied to virtually every known load-bearing material – ranging from asphalt to zirconium, and missing few, if any, of the letters in between. Whether the m...
متن کاملNoise Control in Strain Gage Measurements
Strain measurements must often be made in the presence of electric and/or magnetic fields which can superimpose electrical noise on the measurement signals. If not controlled, the noise can lead to inaccurate results and incorrect interpretation of the strain signals; and, in severe cases, can obscure the strain signals altogether. In order to control the noise level, and maximize the signal-to...
متن کاملA Universal Tare Load Prediction Algorithm for Strain–Gage Balance Calibration Data Analysis
An algorithm is discussed that may be used to estimate tare loads of wind tunnel strain–gage balance calibration data. The algorithm was originally developed by R. Galway of IAR/NRC Canada and has been described in the literature for the iterative analysis technique. Basic ideas of Galway’s algorithm, however, are universally applicable and work for both the iterative and the non–iterative anal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1960
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.26.26