0.9-V CMOS cascode amplifier with body-driven gain boosting
نویسندگان
چکیده
منابع مشابه
CMOS Active-Cascode Gain Stage
An s-domain analysis of the full dynamics of the pole-zero pair (frequency doublet) associated with the broadly used CMOS active-cascode gain-enhancement technique is presented. Quantitative results show that three scenarios can arise for the settling behavior of a closed-loop active-cascode operational amplifier depending on the relative locations of the unity-gain frequencies of the auxiliary...
متن کاملInverter Based Gain-Boosting Fully Differential CMOS Amplifier
Abstract—This work presents a fully differential CMOS amplifier consisting of two self-biased gain boosted inverter stages, that provides an alternative to the power hungry operational amplifier. The selfbiasing avoids the use of external biasing circuitry, thus reduces the die area, design efforts, and power consumption. In the present work, regulated cascode technique has been employed for ga...
متن کاملA 2.4GHz Cascode CMOS Low Noise Amplifier
A cascode CMOS low noise amplifier (LNA) is presented along with the used design methodology and measurement results. The LNA works at 2.4 GHz with 14.5 dB voltage gain and 2.8 dB simulated noise figure (NF). Powered from a 1.8 V supply, the core measured current consumption is 2.76 mA. An output buffer was designed to match a 50 Ω load and its current consumption is 5.5 mA. The technology used...
متن کاملHigh - Gain Wideband CMOS Low Noise Amplifier with Two - Stage Cascode and Simplified Chebyshev Filter Sung -
ETRI Journal, Volume 29, Number 5, October 2007 ABSTRACT⎯An ultra-wideband low-noise amplifier is proposed with operation up to 8.2 GHz. The amplifier is fabricated with a 0.18-μm CMOS process and adopts a twostage cascode architecture and a simplified Chebyshev filter for high gain, wide band, input-impedance matching, and low noise. The gain of 19.2 dB and minimum noise figure of 3.3 dB are m...
متن کاملAdjustable Gain Cascode Low Noise Amplifier
Tower mounted amplifiers (TMA) serve to lower the system noise figure (NF) in cellular base-stations. For performance reasons, the TMA is located as near to the receiving aerial as practical and has to be connected to the rest of the radio at the tower’s base by a long run of coaxial cable. The parameters critical to TMA performance are low NF for reasons of optimizing coverage area, high gain ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Circuit Theory and Applications
سال: 2009
ISSN: 0098-9886,1097-007X
DOI: 10.1002/cta.539