СТРУКТУРНО-ФАЗОВЫЕ СОСТОЯНИЯ ПОКРЫТИЯ ВЭС Al-Fe-Co-Cr-Ni, СФОРМИРОВАННОГО НА СПЛАВЕ 5083
نویسندگان
چکیده
Используя технологию холодного переноса металла (проволочно-дуговое аддитивное производство (WAAM), совмещенное со сварочной наплавкой (СМТ)) на подложке из сплава 5083 сформировано покрытие высокоэнтропийным сплавом (ВЭС) Al-Fe-Cr-Co-Ni неэквиатомного состава. Методами современного физического материаловедения выполнен анализ структуры, фазового и элементного состава, дефектной субструктуры системы «покрытие-подложка». Показано, что элементный фазовый состав, дефектная субструктура покрытия зависят от расстояния до зоны контакта подложки. В слое толщиной 200 мкм, примыкающем к зоне контакта, выявлено присутствие включений второй фазы границах зерен ВЭС, обогащенной атомами хрома железа. Микродифракционным анализом установлено, это включения Al8Cr5. перемешивания подложки формирование нанокристаллической Al2O3 MgAlO размером 10-20 нм субзеренной структуры (размер субзерен 140-170 нм. Структура 1-го типа характеризуется неоднородным распределением химических элементов выявлены области пластинчатой формы, обогащенные Cr сферической Ni, Fe, Co. По границам располагаются наноразмерные частицы (NiCo)3, Al4 Al13Fe4. Высказано предположение о физических механизмах повышения твердости материала в
منابع مشابه
Soft Magnetic Properties of High-Entropy Fe-Co-Ni-Cr-Al-Si Thin Films
Soft magnetic properties of Fe-Co-Ni-Al-Cr-Si thin films were studied. As-deposited Fe-Co-Ni-Al-Cr-Si nano-grained thin films showing no magnetic anisotropy were subjected to field-annealing at different temperatures to induce magnetic anisotropy. Optimized magnetic and electrical properties of Fe-Co-Ni-Al-Cr-Si films annealed at 200 ◦C are saturation magnetization 9.13 × 105 A/m, coercivity 79...
متن کاملCreep of Ni-Al and Ni-Cr-Al Superalloy Foams
The steady-state creep rate of Ni-base metallic foams, with superalloy composition (in wt. pct) Ni7.8∼9.1Al (relative density, ρ = 2.5-2.6) and Ni-13.5∼16.6Cr-5.1∼8.9Al (ρ = 2.8∼3.0), was measured under a range of temperatures (680∼825°C) and applied stresses (0.1∼0.3 MPa), and compared with that of NiAl intermetallic foams (ρ = 5.3). The stress exponent and activation energy are within the exp...
متن کاملPreparation and Test of Fe / Cr / Al - Ni / Cr Composite Film Micro - heater
MEMS gas sensor is one of the development directions of the sensor, and it must work at a certain temperature, so micro heater is an important part of MEMS gas sensor. In this paper, aiming at the high cost and complex process of Pt film heater, we developed the research of Fe/Cr/Al and Ni/Cr cheap metals replacing Pt metal. With Fe/Cr/Al and Ni/Cr metal as the targets respectively, Fe/Cr/Al an...
متن کاملOn Sluggish Diffusion in Fcc Al–Co–Cr–Fe–Ni High-Entropy Alloys: An Experimental and Numerical Study
High-throughput measurement using the numerical inverse method combined with the diffusion multiple technique was employed to determine the composition-dependent interdiffusion coefficients in fcc Al–Co–Cr–Fe–Ni high-entropy alloys at 1273, 1323, and 1373 K. The reliability of the obtained interdiffusion coefficients was confirmed by comparing the model-predicted composition/interdiffusion flux...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Fundamental?nye problemy sovremennogo materialovedeniâ
سال: 2023
ISSN: ['1811-1416']
DOI: https://doi.org/10.25712/astu.1811-1416.2023.01.005